Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Michael Noote I have been testing out various things in packet tracer before I take ccna I just started with my studies butI have nat enable on 3 routers they are all using frame-relay from every other devices in the 3 different network they c...
Michael Noote I am using packet tracer I have a ftp site setup behind nat and I have email server setup behind nat on the network with the ftp server I only put ip nat inside on the sub interface of the fast ethernet port that the server was ...
Michael Noote This is probably a stupid question but when I enter routes into one router using which routing protocol would allow for that route to be sent to all other routers. I am not understanding with this network I have setup in Packet Tra...
Just wanted to thank everyone for all their help with answering any of my questions and the result ended helping me pass my CCENT regardless of how hard or easy it is too most people I was just glad to pass the certification and ca...
Just trying to get my CCENT I am making sure I understand everything I failed my Certification Once Just dont want to fail it againThank you I need help with quite a few concepts and understanding how this works or how they all work I need help under...
Michael Noote HeyI just wanted to say thanks again and after I applied the ip nat outside commands to just the serial interfaces on each router and not their sub interfaces everything pings I also did the same using the ip nat inside commands to loca...
Michael Noote Hey TobyI removed nat off every router and of course everything pings I guess either the inside source commands I had were preventing pinging or me placing ip outside nat to the subinterface instead of the whole serial interfaceand same...
Michael Noote well I went to site 1 I removed all nat stuff inside and outside the on all the interfaces I removed both inside nat commands on that router and the access-list I am sure I probably didnt have remove all that but I went ahead I can ping...
Michael Noote let first off thank you Toby for all your help and input I will try the stuff you recommended I have already tried to input theip nat inside source static 192.168.70.4 Se0/0/0.1 overloadip nat inside source static 192.168.70.4 Se0/0/0.3...
