Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello people, Help pleaseI have simple setup as explained in the diagram and the config of the ASA attachedLAN-->L3 SW 3750G-->ASA5510-->Eclipse modem-->PPPOE-any subnet on the LAN can not ping ASA outside and any public IP (even after I apply ACL, N...
We have two main sites (East Building as DR + West Building as BDR) + 100 remote sites / all connection between the sites based on VPN / OSPFEast building has 1 WLC 5508 with a license of 500 APWest building has 1 WLC 5508 with a license of 500 AP50 ...
Hi guys, Trying to setup WLC5508 with an AP as a pilot, IP schema as belowDHCP: 10.198.10.100WLC: 10.198.10.126AP: 192.168.231.x We are routing between the two subnets via cisco ASA5550.Diagram attached for more explanation-If I assign static IP to ...
Thanks Jouni,it worked, it was routing issue.ASAroute INSIDE 10.4.0.0 255.255.255.0 10.15.15.1 L3 Switchip route 0.0.0.0 0.0.0.0 10.15.15.2Thanks and much appreciate
Hi Jouni,Thanks for your help.Here is what I done-I add icmp permit any echo WAN which let me ping my WAN from the Internet (Perfect / Thanks)-I removed route INSIDE 0.0.0.0 0.0.0.0 10.15.15.1 1 and I did advertise the connection between ASA-SW by EI...
Hi Scott,Vlan mapping with single SSID with diffrent IP based on local vlan is working just perfect ThanksssssssssssssssssssThe failover haven't try it yet, but I'm sure it should work.I'll give a failover try may be within next week or two and for s...
Hi Scott,Man you just answered most of my Q this is going to be good Friday for meI'll give it a go either Monday or Tuesday depends on how much hair left over my head Now below is query-When I create the main 1 SSID / WLANs "Corporate ABC-SSID" ...
