Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,I have a branch network that recently had its IP address changed. The scenario is as follows:old IP & mask10.171.81.64/26g/w: 10.171.81.65new IP & mask10.173.109.0/24g/w: 10.173.109.11 cisco router & 1 HP2710 switchswitch IP: 10.173.109.2All...
Hi Mfurnival,Thanks for your reply.I can't deactivate the old scope because it is still active with dhcp clients. I have tried setting up static IP to no good. Doing this I can't ping let alone connect to it remotely.Regards.
Hi Sri,Thanks for your reply.Both old and new scopes are created on the same server and I was told that IP helpers have been setup on the router.Regards
Hi Richard,Thanks for your reply.The DHCP server is at the HO and the clients are in a branch on a different subnet so yes the DHCP broadcast is relayed via a router in this case.Tracert comes from the old IP subnet. I can ping the new gateway as men...
