About Nate Austin

Nate Austin · 03-01-2011

Hi Daniel,If you are truly in an L3 deployment (where the users reside at least one L3 hop away from the CAS) then you will not be able to use VLAN ID as a valid mapping condition, because the CAS will not know what Vlan the user is coming from. ...

Nate Austin · 02-08-2011

Hi Andrea,In 4.7.2 there wasn't much you could do within the CAM itself - really you could just export them from the GUI into a spreadsheet and analyze based on that.The CAM does have an API however that would allow you to export reports via scriptin...

Nate Austin · 12-09-2010

Thanks for the clarification.So its hitting the rule called "Network Device Authorization" and returning the "Full Access" Shell profile. What are the conditions for that rule? Can you send a screenshot of that page?Thanks,Nate

Nate Austin · 12-08-2010

Hi pemasirid,Can you send a report from the Monitoring and Reporting section of the ACS? Go to that section > Reports > AAA Protocol > TACACS/Radius Authentication (whichever you are using) and click the details icon next to a failed authentication. ...

Nate Austin · 12-08-2010

Hi donaghq,You will more than likely have to reboot (if you didn't save the configuration then it will revert to the old password) or if you did save the configuration after making the change, perform a password recovery via the link below:http://www...

Member Since	‎11-26-2007 10:56 AM
Date Last Visited	‎08-07-2025 01:04 AM
Posts	42
Total Helpful Votes Received	9

User Statistics

User Activity

Re: Cisco NAC - Mapping Rules with VLAN ID

Re: Cisco Nac Agent Requirement type Audit

Re: ACS 5.1 group mapping with AD

Re: ACS 5.1 group mapping with AD

Re: password issue on ACS5.0