Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello. I have been trying to solve this issue for 6 hours now and cannot figure it out. I have a unit that is active and another unit that I reset the configuration and am trying to get it to replicate. I type in failover on both firewalls and it ju...
Hello, I have a PIX 515E set up between our office switch and our Comcast Business Router and the download speeds are not as fast as they should be. We are paying for 30 down 30 up but it's more like 10 down 30 up. I plugged in a computer directly in...
Hello I am trying to setup a VPN tunnel between a PIX and an ASA. I went through the IPSec Site to site wizzard using the same settings but I cannot ping hosts from either side.Here is the setupASA 5520 Device Manager 6.4(5)106Software version 8.0(5)...
Here is a log dump of what is happening on the secondary when I try the failover command. , my state Negotiation, peer state Not Detected.%ASA-6-720032: (VPN-Secondary) HA status callback: id=3,seq=200,grp=0,event=411,op=22,my=Negotiation,peer=Not De...
Hey thanks for responding! They are both hooked up to eachother dirrectly through a CAT5 cable. Here is the failover link config... I know the secondary has "no failover" set. The box switches back to no failover after me issuing the "Failover" comma...
The MTU was the problem, ran a bunch of pings with a do not fragment option until I got to 1272 so 1300 is my MTU. Speeds are closer to what they should be now. We recently switched to Comcast Business and I guess their MTU is 1300. Thanks everyone f...
Please check on the speed and duplex settings whether the downstream and upstream links are fine and healthy.Inside/outside are both set to auto/auto atCheck for the processes usage of the cpu of the pix.CPU is running at 2%Process: tmatch compi...
