Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Just upgraded my 5505 to a new 5506. The network topography has not changed in any way and all objects, NATs and ACLs on the 5506 match exactly to those on the 5505. Everything is working as it should except that I can not scan to email from a Xerox ...
I know this topic has been covered may times, but I am still stuck after reading many forum posts and cisco help files on the subject. Also let me say that I am not a Cisco professional in any way, although I do know my way around the CL to some exte...
I have a production ASA 5505 that is working perfectly. I wanted to take a spare ASA 5505 and copy the running config to it so that I would have a backup unit that could be swapped out if the production unit went down. Both units have security plus a...
I know this thread is older, but this solution may help others in the same situation.My ASA 5506 with FirePOWER was configured and running correctly for over two years. Then I was suddenly struck with this problem, and neither the ASA or my workstati...
AJ,
I have tried both port 25 and 587 based on Microsoft's documentation on connecting an MFC to Office 365. The process fails using either port.
I set up packet capture between the Xerox and the Office 365 mail server. Turns out the ASA is allowing ...
Jouni,Thanks for the light bulb moment. Even if you have the destination interface of the Static NAT set to "any" it wouldnt mean that the traffic would actually take a turn on the "outside". It would simply go straight from "inside" to the "dmz". T...
Harish,I am using the object network webserver from above in my outside ACL, so I believe it is already pointing to the real address.Jouni,Now regarding the "inside" to "dmz" traffic,I am not quite sure how you want the NAT between those interfaces t...
