ASA 5512-x requires new IOS. we discovered today that when we try to upload new IOS to flash either via ASDM or copy cli command the ASA reboots. We are running IOS code 9.1.1
anybody every encounter this?
We are currently using Proxy servers to route outside traffic to the target Firewall. But we purchased firepower for our firewalls and we want to eliminate proxy servers and send targeted vlans to one of the two firewalls of our choice.
Currently we ...
Anybody know how I would turn this IOS 8.2.5 nat statement into a IOS 9.8.1 nat statement?
static (DMZ-ADT,outside) udp ADT-Remote-Access 20000 192.168.13.3 20000 netmask 255.255.255.255
Is it possible to nat as required by the below parameter's?
We wish to nat 192.168.200.0/24 (our private MPLS will not route any 192.168.x.x subnets by design) to another private range that our MPLS will route; 10.52.1.0/24.
We also wish to do the ab...
We have firewall setup to allow ssh from a single public address to one of our switches inside the firewall.
I had Cisco TAC examine acl rules and all is well.
However the ssh connection always times out.
SSH works fine inside.
Anybody know what cou...
Sorry for delay in providing closure on this discussion but at this point this ASA cannot even be reloaded. The reload command does not work.
We are trying arrange for someone at this site to power down and up.
regards
John
The unit is already running 9.1.
Here is why we are trying to load this IOS.
We got notice from Cisco that we needed to upload to this code (asa917-23-smp-k8.bin) because of vulnerabilities in the current code 9.1.1. They say this fixes the vulnerabi...
Here is the path.
N9K>3850>LAN bridge>3750X
The 3850 is L2 switch but has capability of being L3.
The 3750x is running as L3.
The N9K is where all the SVI's are configed.
Vlan 56 and 60 are the wireless and data vlans for this location so the vlans d...
