Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have serveral 3560s and wanted to do a simple QoS for different networks. I understand the bandwidth statement is out and have to use COS/DSCP values. Example:1.1.1.0 network --C3560-S2 \ ...
I just purchased an ASA 5555 and started to configure. I was successful in natting all the IPs that are on the same subnet as the ASA eth0. I could not get the nat working for the 2nd address block. Any ideas?Ex:interface GigabitEthernet0/0 nameif...
Ok. I was able to solve my problem. My ASA software is 8.6. I want not able to create two default routes.ASA had 1.1.1.1 as the outside interface. I could not get 2.2.2.2 to nat, because the ASA doesn't do proxy arp in 8.6My OGW 3750 had 1.1.1.25...
