Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am using a PIX 501 6.3 on a dynamic BellSouth DSL circuit, also I want to setup VPN access fron the outside.Is there a way to configure the PIX to respond to a request from outside after the IP address was changed by the ISP?
Scott,This is encouraging news, one question though. If I am resolving the IP address with a dynamic address service i.e (dyndns.org) and use the name "rscs.dyndns.org" in the address field in the client settings, will the client connect or does it r...
Thanks again Jay,My IOS is 6.2(2)I have read the command refrence you sent but it doesn't show me where to specify the port the information is comming in on.I am using PCAnywhere but I am changing the default ports.Please be paitent with me this is t...
Thanks for the reply Jay,I have the PIX 501 and yes I am trying to allow a remote control application to access from the outside.I need port 10571 TCP to forward to 192.168.1.10 inside.I need port 10572 UDP to go to 192.168.1.10 inside.can you help?C...
