I have a stack of 2960S switches connected to anoth stand alone 2960s switch with a trunk with remote span configured but it doesnt seem to be working. I have the following config on the stack which: monitor session 2 source vlan 5 monitor session 2 destination remote vlan 995 The following config on the destination switch: monitor session 2 destination interface Gi1/0/47 monitor session 2 source remote vlan 995 Both switches have VLAN 995 configured as remote-span vlans. The trunk is configured to allow only vlan 995 I can see on the stack switch that traffic appears to be crossing the trunk and on the destination switch i can see it appears to be recieving the traffic however the output counters are not increasing anywhere near the same rate as incoming counters for example: On the stack switch, output count is: 674163045 Bytes On the destination switch the input count is: 655435515 Bytes However on the output count is only: 135718 Bytes Anyone have any idea what could be causing this? Thanks in advance
... View more
