Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Attached is "Figure 1" which depics a worst case but working multi-vlan configuration which includes the use of the "native vlan" 240 at each point.This works with version 7.035.3 and older covering the last 3 years of use. Here we turn on "VLAN Tran...
Anyone know where or how to get information/instruction to map a Windows network drive to my virtual NCS box so I can access reports and preload firmware?
I am using a 3560 on Root-Bridge side and a Cisco 2960 on the Workgroup Bridge side. Cannot migrate Vlan info to 2960 switch, thus cannot re-assign switchport access on a port to any VLAN other than the Native VLAN. Any way to make this happen withou...
We have a detached building to bridge to. Using the latest JA2 software, configured the A-Radio on the WLAN side as a root bridge, and in the detached building the A-Radio as a non-root bridge. A Cisco 3500 switch resides at both ends connected via B...
Use this at the controller cl1conf tap dot11 24ghz shutdownyap dot11 5ghz shutdowny!ap dot11 24ghz dot11axap dot11 5ghz dot11ax!no ap dot11 24ghz shutdownno ap dot11 5ghz shutdown!end
One thing we noticed was if we had any ap broadcasting a ssid, like a guest network, we had the same issue with our PDA's.. We turned off the broadcast on the guest network and have had no further issues.
