Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,We have a 50Mb cable connection to the Internet at a remote site. We have set up a dmvpn back to a hub router at the hospital which is in another state. We can test straight from the cable modem and we are getting our 45-50Mb speed. The proble...
Hi Joshua,We recently deployed the passive-interface default command throughout our network and the first time I was configuring it I tried to paste the command in along with the 'no passive-interface [WAN int]'. Of course what happened was that as s...
I've got a lot of things to try now. Thanks you everyone. In the end I think this old router just can't handle it. I'll try some of the config changes also. Thanks again.
Leo it will be Monday before I'm onsite and can test the bandwidth again. The high amount of errors on the hub may be from other sites and has not been cleared in a long time. I'll reset those counters. Your help is much appreciated. Monday I have so...
I don't see any. Wait... there are input errors. Below is the show interface output:Spoke interface:CTR-122-R001#sh int gi0/1GigabitEthernet0/1 is up, line protocol is up Hardware is MV96340 Ethernet, address is 0024.97fd.e8a1 (bia 0024.97fd.e8a1) ...
Hi Leo,Yes. It looks like it does have a vpn module. Below is the output of the command:FMC-101-R204#sh crypto engine brief crypto engine name: Virtual Private Network (VPN) Module crypto engine type: hardware Stat...
