Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Recently have purchased few unit of SX2oN and can't find how the preset can be SET and Recall with TRC6 remote, anyone can assist? because during POC SX20 with TRC5 remote was used and also being told that no different between this two model. And...
Not sure your gus have experience this before, I was unable to telnet to C60 codec with TC6.0 (new codec). The Telnet service was enable. Ping and web access is working fine. Whenever I put telnet it keep on getting message like as below. I have p...
Hi there,Anyone have experiment in integration with biamp nexia VC for C90 codec? I can telnet into RS232 port and execute the command but not with nexia VC command line.Because we don't know what 'symbol' in command line representing 'enter' in PC ...
Hi,Understand from TC console manual where C90 can send different camera source to different remote sites in mutipoint conference. But I can't find the section define video input source to individual remote sites. Can anyone share with me how this ...
I just can't register my movi client into VCS started pack x7.1 It keep ON showing messageLogin faileddue to registration failureIf the problem persist contact IT supportFindme address, user account and local database accounts are setup with same use...
Wayne, Patrick, Thanks for the reply ! As I am dealing with VC/TP for the past 20 years and it is the first time I came across PTZ camera can't do preset with system remote. Will try out the web interface option as Touch 10 is too expensive as add o...
I have tried both this config without any IP address and with the IP addrerss of PC wish to do telnet, both case have the same result. I also tried put it back to factory default by web and only configure system IP, enable telnet without changing ...
