Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Because of distance constraints and the environment I run fiber and a 2 conductor copper wire to each of my access points' locations. The 2 conductor copper wire provides the low voltage DC which powers the access point. The AUI to Fiber transceive...
What wireless card from symbol are you using? I currently have the Spectrum 24 cards talking to 350 AP's without any problems. Is this a problem with a single Cisco AP or all of them?
Don,Just a couple of things to check. First when you were able to ping the device from within the VLAN but not from a different VLAN, did you verify all of the network settings (Default Gateway, Subnet mask). If that's all correct I would recomend ...
