Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello support community,
We have encountered unexpected behavior after performing a RP switchover on ASR9922 chassis.
The switchover itself works perfectly, but when previously active RP goes up in stanby state, it boots IOS-XR, starts to synchroniz...
HiHave anyone encountered such behavior?We are importing routes from vrf SGI1 to vrf C3. Both vrf's are situated on one device (ASR-3). Traffic is going in direction from the Internet to the vrf C3, then jumps to vrf SGI1 and goes to another equipmen...
Hi!I would like to know are there any limitations in number of OSPF processes in IOS-XR, especially on ASR9010 platform? Active Packages: disk0:asr9k-mini-px-4.3.4 disk0:asr9k-fpd-px-4.3.4 disk0:asr9k-doc-px-4.3.4 disk0:asr9k-mpls-px-4.3...
Greetings everyone!We are trying to launch twamp light on the remote device connecting to ASR9k. ASR9k has such configuration:service ipv4 udp-small-servers max-servers no-limit TWAMP_REFLECTORipv4 access-list TWAMP_REFLECTOR10 permit ipv4 host 10.63...
Hi guys,Couldn't really get into logic of bridge-domain and hsrp coexistence. How traffic will be flooded?Imagine following topology: Bridge-domain and hsrp is running between ASR1 and ASR2. Host C has two network adapters. Both are in UP state, but ...
Hello,
Thank you for explanation and advises!
We have opened a TAC case in November last year. For couple of months case was put on hold, as we were restricted to make any works and changes in the network. Through that time TAC was searching and loo...
Hi Carlos,Where did You find information, that multiple pools per vrf are supported starting 5.2 ? Couldn't find in release notes..Regarding your question. I can share our experience.We are using option 1. We have created 2nd inside vrf.On the outsid...
Hi Alex!Is it possible open a TAC case and assign in straight to You? ;)))) (joke!)Yes, the situation that is mentioned in the ucmp doc is very close to the ours. In other words the provided solution also worked for us! Thank You very much!!!!Anywa...
Yes, we are facing same problems.Regarding spam, we've decided to allow only smtp traffic, with destination within our own country, because mostly, all spam traffic goes abroad. That helps us to not get any of our IP addreses black-holed.But, there i...
