Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,I was wondering if anoyone out there has a template for Users Acceptance Testing form for Cisco wireless deployments.I would be very grateful if any of you guys can post the template somewhere on the forum or if you may kindly send it to me ...
Hi all,please I need someone to help me out with an issue for the 7921G wireless phones. the scenario is as follows.a big university campus consisting of 6 buildings. it has a total of 300 APs & they are controlled by 3 WiSM blades (6x 4402-150 contr...
Hi Nicolas, thank you very much for your prompt reply. unfortunately, I couldn;t run a debug client. hence, I am going to open a TAC case as per the advise of Federico. hopefully, they will be able to help me sort out the issue. thank you again for y...
ُْEvan, thank you very much for this amazing procedure. I've just converted two 1240 series APs from LWAPP to Autonomous mode. I followed your instructions step by step & it just worked perfectly. also, the entire process took few minutes only to get...
Dear Augustin, Looks like the LAG is enabled on Your controller & you've connected more than one port from your controller to different switches. this is why you are getting this warning & it might cause a serious looping issue & brings your entire n...
