Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The console port cannot be used for outbound dialing as it is only for local console connections (although you can get dial-in modems to work on the console if it is pre-configured).
There are many ways you can set up modems on a Cisco router. You can use standard external PC modems and connect its serial port to either an AUX port or an async port on a router. You can also buy analog and digital modem network modules and WAN i...
Here is what I see happening:The router is dialing out on Serial2/0:15 to the number 01066114433 as a voice call. The call is then rejected with a cause code of 0x8295. The meaning of 0x8295 is as follows: 82 = From the public network near the loc...
The problem appears to be caused by your primary HSRP router being 3620-1 and Link-A. When you make an FTP connection through this router and link, the NAT is built on that router only. This is fine for the control connection, but in active mode FT...
