Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
At first glance the configurations look okay if you are looking for the 1751 to dial to the 3640 upon failure of the frame-relay interface. My preference, however, is to use 'dialer interfaces' where possible so that you don't 'lock out' usage of the...
Sorry Dan, by configuring statics I don't mean static routes. Check out the following URL: http://www.cisco.com/en/US/customer/products/sw/secursw/ps2120/products_command_reference_chapter09186a00801cd841.html#wp1026694 The static command configures ...
That's certainly a possibility, one that could probably be checked out using "debug dialer". However, I have come across this sort of thing myself in the past, even using an ISDN BRI/PRI emulator and the solution has been the change the software vers...
Have you configured any necessary "static" statements which allow higher security level interfaces to talk to lower security level interfaces? (i.e. Office to LAB?).Many Regards,Mark Searle.
Yes, please post both of the latest configs that you tried along with any troubleshooting outputs you may have for the 1751 to 3640 connection. e.g. do a PING and do a 'sh isdn status', also send the output of debug isdn q921, debug isdn q931 and deb...
