Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
does it make any sense to setup "tracker-type ipv6-interface" which track via HTTP probes ?
endpoint-tracker dns_t1
tracker-type ipv6-interface
endpoint-dns-name cisco.com
I tried several configuration but the probe still fails since mo...
Hello,
I checked the description of setup "NAT66 DIA With Centralized Data Policy". The link is below.
There is a sentence : "To configure NAT66 on the service-side of a device, you configure a NAT66 interface within a service VPN on the device........
Hi,
Is it possible to provide the output of 'show ip interface brief' from an SD-WAN router that uses a PIM module with a dual SIM card?
I am little bit confused by these statements :
Only one SIM is active at a time.SIM switching is handled by the ...
Hello,
Please check the attachment for current settings, where Application Probe Class is not enabled yet.
I have simple question about BFD.
How many BFD packets will be in the output "show sdwan app-route stats summary" TOTAL PACKETS, when I enab...
Hello,
I was able to generate FEC between Site 100 & Site 300, in dCloud (Cisco Catalyst SD-WAN 20.14 Foundations Dual DC)
I could see FEC statistics on SD-WAN routers with "show sdwan tunnel statistics fec " command. (Site300-cE1.png, Site100-cE1.p...
Good point.
But then, how is it possible that in Cisco official documentation mentions "tracker-type ipv6-interface" together with "endpoint-dns-name cisco.com"
endpoint-tracker dns_t1
tracker-type ipv6-interface
endpoint-dns-name cisco.com
Hello Dan,
thank you for the reply.
I checked your output.
If you use an "app probe class", then you send fewer BFD packets overall, because BFD packets are sent for each SLA app-probe class separately in a round-robin manner—correct?
I'm trying to...
Hi Jonny,
Thank you for feedback.
Maybe I found out , why I don't see "FEC Loss Recovery Rate" graph on vManage in dCloud.
Applications - FEC Recovery is not applicable for C8000v --> This message indicates that the FEC Recovery feature, which is us...
Kanan,
thank you for valuable answer.
I am wondering, what IPv6 options for DIA solution I have in case I will use the dual stack.
We will be in the same situation, in case we will use dual stack, and IPv6 global unicast address from vpn 500 (servic...
Hi Kanan,
thank you for update.
I am looking for the minimum supported release of Cisco IOS XE and Cisco vManage for DIA feature when I use only IPv6 (global unicast addresses) in the whole network environment.
It means. I don't need NAT64, dual st...
