Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a pix 515 that has a router for its GW on the inside and outside interfaces, however it connects through a 6509 doing L3 routing. My problem is recently we have had the need to introduce eigrp into the network and whenever I start it up on our...
I understand the onvious that the interfaces are different. To give a little background I am in the process of creating a LAN for 200-250 nodes. This is housed in 2 buildings connected by fibre that is switched to ethernet before it hits the cisco sw...
our network has an edge internet router going directly into the FW. The FW then has 3 interfaces going into vlans on the 6509 (dmz's) and 1 interface going into a hub router for other branches P2P T1's. I think mthe problem lies somewhere betweeb the...
This may have been resolved already, however when using xmodem it is important to use a workstation that nothing else is working on. ie: when performing the transfer set it up for 38400 and then walk away. even if checking email or internet it will p...
