Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
For Anyconnect the pool is in the same range as the management interface of firewall. I am able to ping the internal network but not able to access the ASA ssh/https through Anyconnect.Hardware/Software details:Cisco Adaptive Security Appliance Softw...
I created below ldap attribute-map and applied it to the AD server used for authentication. Then created time-range and applied to group policy.In AD server, for users that should have access to VPN only during office hours, I have put value "OfficeH...
I have created an OU=Company, under that OU anouther OU=VPNACCESS, under that group called VPN. I want users only under this particualr group (VPN) to authenticate. However this is not happening. All users under OU=Company are able to authenticate.My...
Please let me know if it is possible to configure Site-to-site IPSec VPN by using dynamic IP to dynamic IP (i.e, dynamic IP on both ends of the ipsec tunnel) using DDNS. On which platforms is this feature available, like only ASA or routers. Also wha...
i have already added route-lookup at the end of the nat statement but it is still not working....nat (inside,outside) source static any any destination static NETWORK_OBJ_172.16.20.0_24 NETWORK_OBJ_172.16.20.0_24 no-proxy-arp route-lookup
Resolved:Create another time-range "AllHours" allowing access for 24 hours and put this value in the "physicalDeliveryOfficeName" field in the AD server. This time-range is only binded to the users in AD server and not to group-policy. In group-poli...
