Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After I had a client associate to the AP.....the SSID seems to be broadcasting all of a sudden. I'm worried what's going to happen when I change it to PoE. Thank you for your help.
I was able to connect but I had to type in the SSID of the AP on an employees laptop. I want the SSID to be broadcasted so that everyone can see it. I just assumed after you enabled the radio and put the settings in it would automatically broadcast...
And when I went into NETWORK INTERFACES > RADIO0-802.11g > SETTINGS (tab) before I could apply the "ENABLE" button it was asking me to put in the RTS Threshold and the DTIM, which I've never had it do. But perhaps it was because Im using an earlier ...
Alright. So at first I just configured the SSID. Now when I exit out of the web browser and open up a telnet session there are configurations that I never even made ( the ip RADIUS source, and the SNMP). I've been careful not to have two managemen...
