Buy or Renew
Buy or Renew
Helpful votes Given
Helpful votes Received
to merge your Webex community account with this Cisco.com community account
No posts to display.
How to route traffic between interfaces on same router
Hi Jerry,By default, 1841 only has two ports.I think 10.10.10.1 is the internet router's, is this top ?If so ,you should use nat in your router.
OSPF and HSRP
hello You should announce 192.168.1.0 255.255.255.248 in every router
Allowing DHCP/ARP broadcast through Nexus3048TP
Hello,First you should config the dhcp on the 3945.And on the Nexus3048 you should:n7000(config)feature dhcp Enable the “dhcp” feature first!n7000(config)ip dhcp relay Enable the “relay” functionality in global co...
Hi,I have done this experiment. Such as:R1#show runBuilding configuration...Current configuration : 1441 bytes!version 12.4service timestamps debug datetime msecservice timestamps log datetime msecno service password-encryption!hostname R1!boot-start...
How to nat between 2 interfaces
hi,I have met this problem,According to the general situation ,config the nat on the two intfaces.The key is using Extend ACL to control the packets how to go.
Date Last Visited
Total Helpful Votes Received
Helpful Votes From
See all >