Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,i've configured squid 3.0 with wccp to asa5510 SW: 8.2.All is working, but when the squid is down, the asa stops redirecting packets to it. Thats fine, but when i start the squid again, it's reregistering at the asa and it is marked as usable, ...
Hello,i've a Asa 5510 configured with webvpn and Authentication over an MS-ADS-Server Windows 2003. Authentication is working perfectly, but password-management doesn't works correctly.If the user password expires in 14 days, he gets an Password-chan...
Hello,we have an asa 5510 with software 8.0. We have to Internet Lines, 1 16 Mbit ADSL and 1 4 Mbit SDSL. Internal Users should use the ADSL for faster downloads so the default gw is the ADSL. VPN should use the SDSL. This isn't the problem, i can us...
hello,i've installed the ssh-Plugin ssh-plugin.080430.jar into our Cisco ASA 5510 Software 8.0(4).I've created an Entry in the Webtype ACL list and in the Bookmark List. When i connect to the ssl-VPN, i can start the ssh-Java-Aplett and enter usernam...
Hello,i'm trying to configure portforwarding on our ASA5510 with ASA Software 8.0(4) and ASDM Version 6.1(5)51I've configured a portforwarding list with "local tcp port" 3044 Remote-Server is the ip of the server, where the user should be able to con...
I installed the new software and now it works.Many thanks for the link. But the workaround is much to complexa simplewccp interface inside redirect in also will reactivate the redirection.
Interesting, so it doesn't seem to be a squid problem. Perhaps, you can open an tac, the ironport appliances should be supported, i think. I'm not sure, how it is with a squid.Tom
Hi,do you mean, portforwarding from external ip to an internal server behind nat?Then, you can do a static NAT with PAT for the serveraccess-list internal_nat_static_3 extended permit tcp host $internal-host eq $port anystatic ($internal-interface,$e...
I'm sorry, but i can't see any attachements.If the tunnel is fully established, then there could be a routing problem. Is it possible, that you are using the same subnet on both sides of the tunnel?Tom
