I'm attempting to register a third party SIP device to the 4331 Router running in CME mode. This process has worked for years on a 2901 router, and originally worked on the 4331 router running IOS 3.16.04. Once I upgraded to 16.4.1, the registrat...
I have been using a Cisco 2901 router with FXO cards and a TCL script to detect DTMF digits for a while now. Since the EOL has been set for these routers, I decided to try the replacement router (the 4331) with NIM cards. However, I'm having so...
We have a 2901 Router running CME with two 4-port FXO cards installed. We register SIP clients to the router and place/receive calls via the FXO ports.We are trying to get the FXO port on the 2901 router to perform a flashhook operation when it rece...
Thank you for the response. However, I had already opened a TAC request, and was told that third party SIP registrations were not officially supported on CME, thus TAC could not offer support.
I have been unable to continue with this testing. When I installed the new firmware, my third party SIP registrations quit working. I'll be opening another forum discussion on the registration topic to see if anyone has resolved that issue. T...
Thank you for the response. I've been working on getting SmartNet on this router, but it's taking longer than expected on our end. Thought I would go ahead and respond now, and I'll respond again when I get the new firmware and test it.Thanks,Mike
I'm not sure that this bug applies to me. It seems this bug is stating that DTMF will not pass at all from the voip side if the call is originated on the voip side. In my scenario, DTMF will pass from the voip side to the FXO port (which implies...
A sample dialpeer follows:dial-peer voice 2 pots corlist outgoing port2 destination-pattern . port 0/1/2My service is defined in:application service dtmf bootflash:dtmf.tclglobal service default dtmfThanks,Mike