Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I just purchased some C3KX-SM-10G modules to allow us to do Netflow on our 3750x switches. I am being told the only transceivers you can install on these modules is fiber. I typically enable netflow on the uplink to our MPLS for these remote sites...
Hello Everyone
We in DC we have a primary MPLS circuit and a less expensive point to point VPLS type circuit. We identify all of our replication traffic via acls and route accross the point to point. Most ACLs are pretty granular which have source...
Hello Everyone
We just started doing policy based routing on our network. We just purchased a layer 2 point to point for replication traffic to offload our MPLS. I have configured policy based routing on both sides. Currently we have multiple AC...
Hello Everyone
We are getting a new point to point service from an ISP and our idea was to route our replication traffic across the new point to point service. We do not want to route all traffic from these hosts across the point to point but only...
Hello Everyone
I am trying to lock down our DMZ a little better while allowing DMZ hosts to have internet access. My goal is to allow hosts to access internet using our core outbound service group which is a small collection of protocols. I want ...
I don't see which one you are talking about? Right now I am trying to use fiber 1 GB and using a fiber patch cord to loop interface so it will come up then mirroring the interface I want netflow on to the module. Kind of sucks so it would be great ...
I am sorry that I did not see the responses on this. For some reason I did not get any notifications.
To answer your question I am shutting down interface on the same switch that my hosts for testing. Cut not be a clearer way for the switch to kn...
BTW
Wanted to point out that we did move to IP named access lists but kept them separate. We may combine later but for now everything is working and always was working.
