Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Having a strange problem with a version 4.1 sensor... It was functioning normally. Then I changed its IP address. This also included changing netmask, gateway, access list, etc, as well as regenerating TLS and SSH keys.Now the sensor can ping out ...
Very soon I'm going to have to change the admin passwords on a large number of Cisco IDS v4 sensors. Also I suspect that they'll have to be changed in CiscoWorks at the same time. (Okay, really it's VMS + IDS MC. But it says "CiscoWorks" on the lo...
Does anyone know the approximate size (in bytes) for a typical RDEP message? I ask because we're setting up some remote IDS 4.x sensors and want to know how much network bandwidth we'll need to allocate for sending the alarm data back over WAN links...
I've noticed that most perl scripts that parse the XML-formatted IDS alarm data handle time in the following way.1. Find something that looks like this:<time offset="0" timeZone="GMT">1065704702260811000</time>2. Extract the first 9 digits.3. Feed it...
> Another alternative you may want to consider is to use syslog.Is syslog event reporting possible for dedicated IDS sensors too? We have many sensors (mostly 4235 model), and maintaining user accounts on every sensor AND for every sensor on every e...
You're right.When I ran ipconfig on the ciscoworks server to verify its settings, I discovered that it had two active network interfaces. Adding an access rule for the "wrong" address caused SSH to start working.I removed the new rule from the senso...
No replies yet...Okay, so is there a text-based program that can be run from the command line on the CiscoWorks server, which changes the settings that IDS MC uses to communicate with each sensor? I could script around something like that if it exis...
