Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi to all!I faced with a task to make wireless devices connect only to one SSID among a few, created on a WLC 5508. Well, I want all corporate devices connect only to corporate SSID, all guest devices connect only to guest SSID.The second task is sim...
Hello, guys! Need your assistance in configuring QoS on a wired network for the ability to watch IPTV on wireless clients' devices with a good quality.What we have: WLC5508------ trunk ------3750------ trunk ------2960------access------AP1140...
Hello, guys! Need your assistance in configuring QoS on a wired network for the ability to watch IPTV on wireless clients' devices with a good quality.What we have: WLC5508------ trunk ------3750------ trunk ------2960------access------AP1140...
Hello! Is this a problem from Apple or Cisco side?we have a cisco WLC 5508 on which few SSIDs are configured, and two kinds of APs: AIR-LAP1142N-E-K9 and converted AIR-AP1141N-E-K9.When in WLAN settings we leave WPA2 policy and AES encryption, iPads2...
Hello! we have WLC 5508 (6.0.188.0) and some converted APs AIR-AP1141N-E-K9. Everything works fine except one moment:1 of this converted APs is located beyond the office building, but it is still connected to our local network as if it was located ...
thanks for the answers, but we don't have a Radius Server. The solucion that we were advised and that we will use is based on Group Policies. Seems that it works here is the link for if anyone will face the same problem:http://www.grouppolicy.biz/201...
well, our wireless network is built on WLC and LAPs, allocated around the building. on WLC we have 2 segments - corporate and guest --> SSID_corporate and SSID_guest that are broadcasted by all the access-points. For some reasons we don't want to per...
You can even specify the MAC address and tie it to a DHCP server. You can then assign a 169.X.X.X IP address.what a interesting solution! but when I try to do that - I get the following response:The specified DHCP client is not a reserved client.wel...
Finally, I have found the solution. Thanks to the article that advised me an engineer of cisco TAChttp://www.cisco.com/en/US/products/ps6366/products_tech_note09186a0080ab7c01.shtml#First I did ALL the recommendations that are described there and iPa...
not one, ALL the iPads WLAN Identifier.................................. 3Profile Name..................................... NovyGuestNetwork Name (SSID).............................. NovyGuestStatus........................................... E...
