About dgj

dgj · 07-11-2005

i know I can set static routes using ip address for hosts:ip route a.b.c.d 255.255.255.255 192.168.1.1However is it possible for these to be dynamic for webhosts whose IP addresses may change and mess up my internal routing!eg.ip route app.hostname.c...

dgj · 03-01-2005

I'm using the following modules in a Cisco 3725WIC-1SHDSL 1-port G.shdsl WIC (two-wire only) WIC-1SHDSL-V2 1-port G.shdsl WIC (two- or four-wire) I've tried the following IOS versions :c3725-entbase-mz.123-11.T.bin&c3725-entbase-mz.123-11.T2.bina...

dgj · 09-17-2004

i've set up a dsl vpn using cisco 837need to be able to use tacacs and other stuff (such as tftp) but the connections appear to be attempting with the internet IP address rather than the routed LAN IP(inside the VPN on the b-end)Ping (extended) works...

dgj · 08-12-2004

What are the pin outs of the above card when required in a 4-wire circuit?Has anyone used these with EPS8 (UK), and if so, do you have the cable configurations (RJ-11 <-> Tel Jack)?Thanks

dgj · 05-19-2004

I've just had a Cisco 2621 fail, and am trying to get a tftpdnld of IOS onto it, but that's failing as well.On boot up:===========System Bootstrap, Version 12.2(7r) [cmong 7r], RELEASE SOFTWARE (fc1)Copyright (c) 2002 by cisco Systems, Inc.Testing lo...

dgj · 09-24-2004

is it possible to set the "inside" interface as default for all connections out?i'm able to ping etc. from PC's behind the router, but it seems to me that any other connections from the router itself have their source as the "external" IP address.......

dgj · 09-16-2004

Anyone with any ideas on EPS8?

dgj · 05-18-2004

if you have a config in a text file, add no shutdown underneath any interface entries...eginterface Ethernet0 ip address w.x.y.z 255.255.255.0 no shutdown

dgj · 05-18-2004

I probably haven't explained properly!There aren't any routers on the other end as the links are IR and wireless(microwave) and the default gateway for the network on the other end of the link(s) is the 7206.If I have to I probably would be able to p...

dgj · 05-17-2004

the 7206 is the default router for this siteso can I specify ip address as 172.x.y.1 on both interfaces?it's going to be difficult to test this in a live environment!!!!

Member Since	‎10-17-2003 05:56 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	24
Total Helpful Votes Received	5

User Statistics

User Activity

ip route "static"

WIC DSL Modules

specify default port for connection

WIC-1SHDSL-V2

2621 failure

Re: specify default port for connection

Re: WIC-1SHDSL-V2

Re: newbie - copy config to 806 router

Re: Failover link 7206

Re: Failover link 7206