Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,How to configure SAN Boot on the UCS C Series platform ? On B Series, we can configure the boot order from vHBA, but on the UCS C Series I found nothing.The C Series SAN boot had being enabled and also the boot target was configured on the vHB...
Hi All,Usually, we do the cabling of FI to IOM as following :Left IOM to FI-A and Right IOM to FI-B (Attachment Cabling A)Is posiible if we connect the Left IOM to FI-B and Right IOM to FI-A (Attachment Cabling B) ? Any impact and consideration ?Real...
Hi All,I tried to connect the FI FC port to the Nexus 5K. The FI was configured in end host mode (NPV), while the N5K was configured as NPIV switch (NPV core switch). After tried a lot, the SAN PortChannel link on both FI and N5K can't brought up, st...
Hi Padma,After a week of troublehooting, finally I found the issue. I just do CLEAR BIOS CMOS over CIMC of C Series. And then the vfc appear on the N5K, boot correctly through the SAN.It seems that the C Series has cache of booting order save in the ...
Hi Jose,The common steps to configure FC on FI and MDS as following :1. FI configured in NPV mode, ensure that all FC uplinks and vHBA of Blades have been assigned on correct VSAN Verify if vHBA Flogi into the FI show npv flogi-table show n...
Hi Jose,Have you configured the zone with the member of ESXi and the drive ? After configure the zoning, ESXi will have their datastores (you can present the datastore on the ESXi).If you want the windows guest running on the host ESXi to have their ...
Hi Jason,Why you need the route ? From your configuration, it seems that the route on the same network on vlan 200 vrf context iscsi ip route 172.20.9.0/24 172.20.9.254The route already directly connected, I think you don't need any route to the same...
Hi Jose,Configure the FI on it default mode (End Host Mode or NPV), enable NPIV on the MDS. This configuration will cause MDS to provide all zoning informations while the FI act as the Host with a lot fcid login to the MDS. It means that the zoning c...
