About damige1985

damige1985 · 12-17-2012

Hello Gentlemen,Our company is experiancing difficulties connecting a (Stretched Layer2) Dot1q trunk between DC and DR sites.Our current setup (which works without problems) is a basic Dot1q trunk (on both sides) running a vlan allowed list and filte...

damige1985 · 01-21-2013

I think you are confusing MegaByte(MByte) with Megabit(Mbit).8Mbit = 1MByte100Mbit = 12MByte1000Mbit = 120MByteat 100Mbit it would take a 300MByte file 25 seconds with no overhead( ~30 sec with basic TCP/IP overhead)at 1000Mbit it would take a 300MBy...

damige1985 · 01-02-2013

try setting the port to"switchport""switchport mode access"Hope this helps

damige1985 · 01-02-2013

U could remove the ip from the fa0/1 interface and put it on interface vlan1.This would make the ip reachable from all the ethernet card ports. Use the fa0/0 or 0/1 as "uplink" ports.not so reccomended, but could work, (incase you REALLY need the 5th...

damige1985 · 12-17-2012

Thanks Guiseppe

damige1985 · 12-17-2012

Hello Guiseppe,We have contacted the ISP and they informed us that they limit the links to 200mac-addresses.This solves this issue we had, but gives us a new problem. How to limit our mac-adresses. NAT overload is not an option nor is making the inte...

Member Since	‎12-17-2012 05:03 AM
Date Last Visited	‎02-08-2021 01:12 AM
Posts	7

User Statistics

User Activity

ARP issue?

Re: Bandwidth...utilization issue

Re: Vlan config

Re: Bridging routed ethernet ports to L2 switchports on a 2801

Re: ARP issue?

Re: ARP issue?