Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have two WS-C2960S-24PS-L switches. One was set up with a configuration that worked for our network, but we now have need of the additional ports in the second.I installed the FlexStack modules, as per the instructions, and co...
I didn't, unfortunately. The two units are sat to one side at the moment. I had to replace them with some Catalyst 3750 switches to get the site up and running.I'll go back to them one day. I think the problem was, I had the config set up before I c...
Yeah, several times. Even tried swapping the FlexStack modules around once, which did nothing.OK, I've got that config applied to port 6 on the master, now connected to Port 6 on the second switch. Phone is connected to an unconfigured port, but is ...
I've probably done something wrong, but the phone can't even pick up a DHCP address now.I've cleared the config from Interface GigabitEthernet1/0/6 and connected that to a unconfigured port on the second switch witha Cat5e cable.I've done 'Conf T' ...
I've got none of those available, but wouldn't that create a cluster, and not a stack?I don't have a config on Switch 2, as I believe is requirement for Stacking, so if I attach it as a secondary switch, I wouldn't have any connectivity anyway would...
Yes, I can get an IP from the DHCP server, and I can see the device listed in the DHCP Console on the server.I can't PING the device and I can't PING from the device.At the moment, I only have a VOIP phone connected, and it's constantly trying to co...
