Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a few questions about trying to configure an FTD currently configured with multiple inside interfaces using source NAT to outside to work properly with a second ISP for failover purposes. I'm not trying to divide specific traffic between the t...
Hello, We're having a problem accessing an outside SFTP server and suspect the problem has to do with the ASA. The connection is unexpectedly dropped. I seem to remember a while back having similar issues, but can not remember the solution. Is there ...
Hello All, Just want to run something by the forum... I have an ASA 5508-X with 2 inside interfaces and I need to allow traffic between two hosts on each interface. Host 10.100.15.10 on VLAN10 needs to be able to access host 10.100.10.10 on VLAN30 an...
Hello all, I need to be able to remote manage about 10 routers using dial-up modems. It's kind of an old school way of doing things I know, but unfortunately, the sites are in rural areas, most of which have only one ISP option and bad or no cell ser...
Hello, We have a server on our internal network that we are currently using port forwarding to allow accessibility from the outside and I am considering placing it in a DMZ to limit potential attack surface. The problem is that clients on the inside ...
I used three inside-outside NAT mappings in my example, but in reality there are actually 12 so I was trying to avoid having to create that many. If that's what has to be done though so be it. I just thought there might be a simpler way.Your second s...
The connection fails almost immediately. I can see it connect initially then it fails with unexpected error. I seem to remember something about the ASA not being able to inspect the data traffic because the connection is over SSH, but I’ve been unabl...
I have usr courier modems.So it sounds like I would need two routers with FXOs for each of the two modems and another router with 2 FXS cards for the PSTN and wic1t cards for the connections between the routers?
I have 3 2811s and z as bunch of wic1t And cables so that’s not a problem, but what do I need to connect the modems and create dial tone for them? i think I need A couple of FXO modules to connect the modems, but I’m not sure if that’s all.
