Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I have an office supporting between 100 to 150 wireless users. I have 3 x Cisco 1142 Stand alone AP's setup in autonomous mode as root access points.1x VLan (May introduce 2nd as a guest later down the line)Security is WPA2 - AES CCMPI have severa...
Looking better as the encryption is the same. but now only the 2GHz radio is broadcasting and not the 5GHz. It has the ? instead of SSID. and also no tick next to in the Securiyt page. Is there a way to make 5 GHz broadcast vic CLI?Thanks again for ...
Even if I go through the process of unselecting the 5GHz radio from vlan. Save. Reboot. Re-enable on the VLan. Save. Enable the 5GHz Radio on SSID. I get error:ERROR:VLAN '1' doesn't exist on 'Radio1-802.11N 5GHz' (see Services> VLAN) ERROR:VLAN '1' ...
So I disabled the 'Radio1-802.11N 5GHz' on Vlan 1 and now its part of the same group on my wifi analyzer for the 2.4GhzNow I have to get 'Radio1-802.11N 5GHz' on the vLan 1. any ideas.
Thanks, seems you were right on the money again, and I think you are right, I've set to to broadcast and is displaying the correct SSID however as a seperate entry. This is because it's encryption is shown as {WEP}{ESS} and not {WPA2-CCMP}{ESS} even ...
Thanks for your help. The radio has come up after anlaysing what channels are in use and selecting one thats not in use. It's now set to a channel with DFS enable and romaing between the two is quick and seamless.I have a third AP at the other end o...
