About CarolChiz

CarolChiz · 07-01-2015

I have an SG500X-48 with firmware 1.3.5I did not upgrade to 1.4.0.x because the release notes saidProblem: When Sx500 devices are connected in a ring topology, the IP mroute entry, learned through IGMP proxy, flaps. (CSCun67979)Solution: There is no ...

CarolChiz · 03-05-2015

Trying to reset the admin password for a SG500 switch.I have console access.It looks a lot like this:https://supportforums.cisco.com/discussion/11523086/sg200-26-password-resetHowever when I press 3 to chose the password recovery procedure and enter ...

CarolChiz · 07-01-2015

I'm sure I won't be able to understand an RFC :)But can you answer my first question. Is this still an issue in 1.4.1.03

CarolChiz · 03-06-2015

For any other newbies like me:look at LED to see which is masterConnect the the master on consoleSerial cable, hyperterminal, 115000 baud, 8 data bits, no parity, 1 stop bit, no flow controlpower down all the stack except the masterpower cycle the ma...

CarolChiz · 03-05-2015

Thanks this works perfectly on the standalone switch.On the stack:When you say remove from stack, do you mean unplug the linking cables?Do I power it all down first?When do I put them back?Will the master then "fix" all the slaves and recreate the st...

Member Since	‎03-05-2015 12:08 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	5

User Statistics

User Activity

SG500X-48 firmware release notes question

CISCO SG500 password reset

I'm sure I won't be able to

For any other newbies like me

Thanks I will test.On the