Hi,  Do you mean controllers support mobility group if run version up to 7.X.X?  In this case, controllers support as you said, right? Both of controller are fully license if one controller is failure access points where connected to its will be down. Regards ... View more

It is impossible to reverse to primary controller as instruction. ... View more

Hi Abraham,   I tried Scott's method it works with my notebook. I will find VCI of CAP 1700 or as your example above.   Thank you, ... View more

I configured 2 types. 1. switchport mode access switchport access vlan management (VLAN 11) On DHCP with Option 43 2. switchport mode trunk switchport trunk native vlan 11   This error apply only AP1702 but AP1602 is fine   Thank you   ... View more

Hi Abraham,   If VCI is incorrect but why it works with another AP.   Thank you ... View more

Yes, the AP is directly connected to POE switch. My laptop can get IP address at the port but AP cannot. *Mar  1 00:05:29.503: %CAPWAP-3-DHCP_RENEW: Could not discover WLC. Either IP address is not assigned or assigned IP is wrong. Renewing DHCP IP. *Mar  1 00:05:58.055: %DHCP-6-ADDRESS_ASSIGN: Interface BVI1 assigned DHCP address 192.168.11.72, mask 255.255.255.0, hostname APa89d.2177.xxx   At the port I plugged AP1602 and working fine. ... View more

Me too.   Sometime make the AP loose connectivity to WLC and did not come to join again. Reboot AP is not fix this. ... View more

Hi Scott,   I tried with my notebook is fine but AP cannot. I tried to reset AP to factory and rejoin again but it still cannot. What should I do next? I should open this case to TAC, right?   Thank you ... View more

Hi Scott, You mean I should use DHCP to make AP join WLC then change to static, right? But now I faced the new problem that I use DHCP but AP did not get IP address.   Some message showing:- *Mar  1 00:04:27.279: %CAPWAP-3-DHCP_RENEW: Could not discover WLC. Either IP address is not assigned or assigned IP is wrong. Renewing DHCP IP. Write of event.log done   Please advise. Thank you ... View more

Hi Scott, I did 2 things. First is a static IP of AP (not in the same subnet) and option 43 enabled on DHCP. Second is DHCP but now it is showing "Translating "CISCO-CAPWAP-CONTROLLER"...domain server (255.255.255.255)" all the time after boot finished and LED status is rotating of 3 light.   I try to configure the static IP with SMB Cisco switch and sure that correct VLAN and configuration. However, It still cannot join to WLC.   For example, 1st floor I configure VLAN 11-14 and use 11 is management VLAN of AP (native vlan 11) then AP can operate with static IP. 2nd floor same configuration on switch but cannot.   Thank you ... View more

Hi Leo,   I need to use a static IP and not in the same subnet. what should I do?   Thank you ... View more