About dbkirkland

dbkirkland · 08-06-2013

Hi,I have dsl modem set for bridge, and RV180 set for PPPoE, and I need to be able to access the modem status page. I have not be able to figure out how to do this.With my old Linksys modem I would just put the following in the firewall script:iptabl...

dbkirkland · 08-26-2013

Looks like the Genmask for the first entry is wrong. It should end in 0, not 255.

dbkirkland · 08-14-2013

While I have the RV180 (not RV180W), I fully agree.When I reset or reboot the RV180, the reboot counter starts at 150 seconds. But it takes another 20-30 seconds AFTER this counter expires before the LAN activates. And if I log into the RV180 at ar...

dbkirkland · 08-13-2013

I know how to set up both my computer and the router to connect to the modem. This is NOT the problem. The problem is that when bridging the modem and using PPPoE on the router, there does not seem to be any way to configure the router so it can see...

dbkirkland · 08-13-2013

I had the same problems when I was using IE10. Seems the RV180 does not support IE10.I am now using IE9 and now it seems to work both with and without the setup wizard.

dbkirkland · 07-31-2013

I had this, and other problems using IE10 on win7pro with firmware 1.0.2.6, so I downgraded to IE9 and now everything seems much better. With IE10 I was unable to set static DHCP on firmware 1.0.2.6, but with IE9 I could.With firmware 1.0.3.10 I ha...

Member Since	‎07-30-2013 10:57 AM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	7

User Statistics

User Activity

Modem status with RV180 and PPPoE?

Re: RV 180 PPTP - LAN users can not access remote users.

RV180W with Firmware 1.0.3.10 - CPU Problem

Re: Modem status with RV180 and PPPoE?

RV180 Firmware 1.0.3.10 cannot set static IP

Re: RV180W static DHCP