Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi. I am attemting to configure a Cisco Aironet 1130AG series access point (AIR-AP1131AG-E-K9) and after I reset the AP, I cannot access the web interface. When I enter the IP address in Internet Explorer I receive the following page after entering...
I finally got this sorted out. I had the IP address on my laptop set to 10.0.0.1, and when I tried to load new firmware it constantly timed out regardless of what I did. When I changed the IP address to 10.0.0.2, it worked perfectly. Here is the ...
Hi Scott,I put this project on the side for several months and now I have made a bit more progress. I was able to upgrade the firmware to c1130-k9w8-tar.124-25e.JAO5.tar and that went perfectly. However, I have absolutely no web console now. The i...
Hi Scott,The AP1131AG does not have a serial port. According to these instructions, http://www.cisco.com/en/US/docs/wireless/access_point/1130/installation/guide/113h_c4.html#wp1085302I need a nine-pin, female DB-9 to RJ-45 serial cable which I do ...
