Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have an older 2811 router running 'c2800nm-advipservicesk9-mz.124-10.bin' in Mexico. Two VWIC2-1MFT-G703 cards are installed for the E1 lines (2Mbt) and combined into a multilink. Getting output drops on the multilink but the serial lines a...
Hello,I have a 5520 ASA running ASA Version 8.4(4)1, ASDM 6.4(9) that has remote access VPN enabled and hands off to a Windows 2008 R2 box handing out DHCP addresses. We attempted to make an IP address reservation based upon MAC address for a single...
Hello,I have a MPLS site that has 2811 router with a Multilink setupinterface Multilink1bandwidth 4098ip address 10.19.191.65 255.255.255.252ppp multilinkppp multilink links minimum 1ppp multilink group 1max-reserved-bandwidth 100service-policy outpu...
The main problem is the connection back to a Oracle database. Any latency and the connection drops to where end user has to log back into this erp system.There is a Telnor/Telmex LEC in the middle between us and AT&T providing two CSU/DSUs and, from...
sh controller e1E1 0/0/0 is up. Applique type is Channelized E1 - unbalanced No alarms detected. alarm-trigger is not set Version info Firmware: 20060711, FPGA: 13, spm_count = 0 Framing is UNFRAMED, Line Code is HDB3, Clock Source is Line. CRC...
sh int Serial0/0/0:0Serial0/0/0:0 is up, line protocol is up Hardware is GT96K Serial MTU 1500 bytes, BW 2048 Kbit, DLY 20000 usec, reliability 255/255, txload 12/255, rxload 33/255 Encapsulation PPP, LCP Open, multilink Open Link is a memb...
Slowly came to my attention as a Oracle DB app that is time delay sensitive started disconnects and then complaints.interface Multilink1 bandwidth 4098 ip address 10.19.191.65 255.255.255.252 no cdp enable ppp multilink ppp multilink links minimum 1...
