Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,We have 2 nos SG-500-28 port Gigabit stackable managed switch and 1 no 48 Port SG-500 PoE Switch. Our problem is that, once we reboot the switch interface and trunk configuration is missing. And we need to reconfigure the interface and trunk...
Hi All, We have a IP network setup with 3 locations Bahrain, Qatar, Oman (Bahrain 5510 Version 8.4(2), Oman ASA5510 Version 7.0(8), Qatar 5505 Version 8.4(4)1). All the tunnel is up between 3 locations and all the traffic are passing through the tu...
Hi All,We have a IP network setup with 3 locations Branch-A, Branch-B, Branch-C (Branch-A 5510 Version 8.4(2), Branch-B ASA5510 Version 7.0(8), Branch-C 5505 Version 8.4(4)1).All the tunnel is up between 3 locations and all the traffic are passing ...
HI, Thanks for your reply.Yes. We did copy from running config to startup config.Please find attached backup configuration with this mail for your reference.Thanks in advance for your support.
Hi, Thanks for your reply.. We solved almost all the issues. Now problem is that from 192.168.1.0/24, can not communcate 192.168.42.100. But from i can reach from 192.168.42.100 to 192.168.1.0/24 range. please find below informations of Packet-tracer...
Hi,Thank you very much for your quick reply. I am facing this issue for 3 days and couldn't find any solution yet. It will be highly appreciatable if you can answer. Once again thank you very much for your reply.
