Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are trying from last two days but We are unable to bring tunnel up between CIsco router 1941 and SRX firewall 550. Setup is simple as below Cisco router--------Modem(Public Dynamic IP possibly PAT)-----------Internet------------SRX 550Ipsec Tunnel...
I have 5512 with 8.6 and I need to allow traceroute through it for troubleshooting purposes. As Inbound traffic has to be allowed specifically for original address on 8.6, do I have to allow entire Inside subnet in case I want my entire subnet to be ...
I am facing strange issue on my asa and client Fortigate fw. We have site to site tunnel with 3des and sha and DH-5 on asa3des sha1 and dh-5 on Fortigate.Tunnel came up when configured after some time it went down and it is throwing below erro...
Hello Johnyy,Can you please share what you understood from this? and which one should be used? Or if I say I want to enable statefull failover so that when my Primary firewall goes down, all the connection information should be passed to secondary se...
Hello,So which one should be used? Or if I want to enable statefull failover so that when my Primary firewall goes down, all the connection information should be passed to secondary set and secondary to act as active one. For this do I need to enab...
Matching ISAKMP policies were configured on both devices as my ASA was trying to compute DH pair.Issue was with DH pair computation which worked after reboot. you are right about below logs:Aug 25 10:40:35 [IKEv1]: Phase 1 failure: Mismatched attrib...
Hey All,I experienced same issue with my another tunnel. Lately I came to know it was higher level of DH computation which my ASA was not able to perform and ASA reboot worked here. See the logs for tunnel which came up after reboot.Eror Before Relo...
