Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Need some clarity on VTP Pruning.What I understand:When pruning is done on trunk interface of a switch, the data frames corresponding to pruned VLAN will not not pass through the Switch's trunk.Here is some doubt on VTP Pruning:Q1) Can VTP pruning of...
Hi All,I am new to CCNA and doing with switching part currently.I am facing issue in understanding how is the entries in the MAC address table of the switches are made.What I know is: MAC addresses in MAC Address Table of switches is the MAC of hosts...
Thanks Rolf,1) VTP pruningCould not find the below command on my switch: Same is mentioned in the shared link.Switch-A(config)# vtp pruning
Switch(config-if)# switchport trunk pruning vlan vlan-list
or command: Switch#sh interfaces gigabitEthernet 1...
Thanks Joseph and Karan for correcting.Switch operates in full duplex mode by default. No CSMA/CD operates.It was wrongly written.Thanks to clarify that Switch defaults to Half duplex for backward compatiblity.@Joseph:As you have written: If they and...
Hi WEI,Here is some light on Half/Full Duplex and CSMA/CD. Half Duplex and CSMA/CD:1. Hub and Co axial cable operate in half duplex mode. (Communication is possible in one direction at an instant.)2. CSMA/CD is an access method used in half duplex co...
Hi,Explaining the scenario:When a port connected to 1 host belonging to a VLAN is access and not trunk.Access Port: Such ports belong to 1 Vlan only ( 1 data Vlan + 1 Voice Vlan) Data from and to access ports are always untagged.Tr...
Thanks Rolf for encouragement and response to all the queries.I will surely go through the VLAN discussion shared by you. STP part was quite tough to interprete in your last post; but it's ok, as I will restrict myself to CCNA level for now. And Yes ...
