Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi ,I'am extending my home internet connection to separate room as Wifi is not reachable over there ,So my setup is something like this , ISP Router > Cisco Switch >Cisco AP1131AG .ISP ethernet cable is terminating on Cisco port 24 ( fas 0/24 ) ,AP i...
Hi ,I'am doing a core swith migration 4506. I need to find out the servers attached to my core switch,the problem is some time I'am getting the ip address and some time ip address is not comming, I'am doing this with this command,Switch # sh mac-addr...
Hi,Can any one tell me please do we have collisions in a Switch if yes 1. how to avoid Collisions in a switch and 2. Define Vlan Tagging. Can anyone please answer my two questions.Thanks.
Hi Guys,I got an interview next week I said that I got knowledge of Nexus 3000, can anybody help me please reagarding the basic commands of NEXUS 3000 and a general overviewThanks.
Hi Guys,I'am new to this forum, and I must say it's very informative .Can any one help me with some CCNA trouble shooting scenarios and it's solution ( Any troubleshooting problems at work),I will be very gratefull.Many Thanks.
Switch#sh run inter fas 0/24Building configuration...Current configuration : 87 bytes!interface FastEthernet0/24description ****ISP Link****switchport mode trunkend_________ *** AP Radio Config ***ap#sh run inter doap#sh run inter dot11Radio 1Buildin...
Switch#sh run inter fas 0/24Building configuration...Current configuration : 87 bytes!interface FastEthernet0/24description ****ISP Link****switchport mode trunkend_________ *** AP Radio Config ***ap#sh run inter doap#sh run inter dot11Radio 1Buildin...
Yes , PC is configured as DHCP .. Please see the config below for switch and AP , Many Than =~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2020.10.23 09:02:28 =~=~=~=~=~=~=~=~=~=~=~=sh runBuilding configuration...Current configuration : 1266 bytes!version 12.2no ...
Hi , Thanks for your reply , do I need to configure any DG in switch or AP ? I can see the AP is broadcasting the SSID and I can connect to it , but still I'am not able to access to internet .
