Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
a friend of mine today bought Cisco 1941 router to replace another older router, The configuration is very simple -> ISP ADSL modem(192.168.2.1) - 1941 router - LAN(192.168.3.0/24)But i am having a headache since the most basic config is not working....
Hello,I have a proplem configuring RV320 with the odd IT setup of my ISP,One of my clients wants to be able to give access to his internally hosted database to his partners and bought a public ip from his ISP, Previously his broadband configuration i...
Hi did you manage to bring the network up ?I am stuck as well because I can not pair bond1 with enp6s18 interface which Proxmox uses as net01: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000 link/loopback 0...
Thanks a lot Jon,I never thought that private IP range can/should be NATed, This is going to be the lesson of the week for me!!!For anyone else who stumble upon this while googling, here is the configuration that worked. !interface Embedded-Service-E...
You are right JonHere is the routing table againR1#show ip routeCodes: L - local, C - connected, S - static, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - ...
HI Alex,No that is not possible, to clarify the setup more, the WAN IP and the Public IP have both to be setup on the same interface and the Broadband modem that the Router is connected to only have one RJ45 port. The WAN IP enables the connection wi...
