Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello:I am trying to setup active/standby failover on a pair of ASA 5505's that have the security plus license on them. Whenever I enable failover though, they seem to not want to talk to each other and I am at a loss as to why.In terms of setup of ...
Hello,When using a SPA-932 attached to an SPA-962, I am trying to figure out how to perform a transfer on an Asterisk PBX. I have tried setting fnc=sd;sub=#700@asterisk-ip on one of the line keys where # is the transfer key and 700 is the extension t...
On the SPA-932 (attached to an SPA-962), is there any guide to configuring the keys to perform a speed dial with a delay?I am trying to set a key to perform a transfer which requires dialing # and then a number. It is going to park a call so the ext...
I can ping between the ASAs using another interface/vlan. The failover interface I cannot ping as it seems to not have brought up the addresses yet on the secondary since it hasn't joined the primary.From the switch I can ping either on an alternate...
That is what I thought too Julio, and that is why I got more confused, because the primary (the one showing down) is the only one I *can* ping from the switch....You can see the interface status in my sw01.txt file attached where I ran a sh int gi1/0...
Yes, as I mentioned, I have the security plus license on both ASAs.I am not seeing much in terms of logs which is why I am a little stuck. From the show failover history on ASA01 I get the following which the 10:07 is roughly when I enabled it again...
Yup, I had posted and then after it didn't show up for a few hours I had posted again thinking maybe I had just done something wrong or mis-clicked. Then realized it was in moderation queue.
