Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi people,I have a WAP4410N-E V02 with software version 2.0.6.1 buyed 2 months ago that restarts every 24/30 hours (about).The device is univocal in the network and is configured as an access point without dhcp server. I activated remote syslog and s...
I people,i have a cisco rv082 router (firmware 2.0.0.19-tm version) configured in load balance mode with 2 wan (wan1: ADSL, 20MB in, 2MB out; wan2: Sincronous DSL 4MB).I have the following problems:1) the dhcp service often does not release the addre...
Dear Jeffrey,thanks for your answer.I have only one doubt, i think my router has the hardware v2 and therefore not compatible with firmware that you have indicated. Is correct?The serial number is NKS10190500.Kind regards,Ruggero Giordano
