Hi Kelvin,
I think now I have a better picture, so if you want to access the ASA using ASDM using the management interface, then the port where the management interface is connected to the switch should be configured, for example:
On the ASA s...
Hi Diiey,
I think I know what the problem is, is about subnetting, please check the following:
When the ASA is configured with ip address 10.38.50.1/16 with mask /16, it is within this network range:
Network: 10.38.0.0/16
With a range of ho...
Hello Phillip,
That is OK, sorry for the late response, I have been busy...
So from what I understand then the inbound traffic is working fine from outside to DMZ, you are having issues with the outbound traffic from DMZ to outside, when the traf...
Hi Diiey,
Sorry for the late response, I have been busy, on the ASA I would need you to run the following command:
show arp | in 10.38.50
Also could you please let me know what is the ip for the switch? I understand the ASA's ip is 10.38.50.1, ...
Hello Kelvin,I would like to apologize for the delay in the response, I've been a little busy, to answer your question if you want to access the ASDM using the guest network and this one can reach the ASA firewall or it is a directly connected networ...
