Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
the purpose of this was to have a loab balancer in OTV to have server_farms in OTV across Datacentersthis is all setup with OTV already in placei'm spanning vlans 500-510 and 600-610 in OTVVLANs 506 thru 510 are soley behind the Load balancerFirst Vi...
I'm sure this config can be modified to use multiple fastE or GigE interfaces rather than Cell interfacesthe purpose of this was to have multiple servers to access the internet; out it's own 'cell' card depending on which VLAN they are onVLAN210 goes...
turn terminal monitor on'term mon'you will see there is a TCAM limit:%ACLQOS-SLOT1-2-ACLQOS_FAILED: ACLQOS failure: TCAM region is not configured for feature SPM NAT outside class IPv4 direction ingress. Please configure TCAM region NAT ACL[nat] and ...
i have a pair ACE load balancers, within my OTV environment ~ one at each datacenter;i simply added a NIC from each ACE onto the streatch OTV VLANthe Load balancer doesn't care cause it's all L2 between the Load balancersas far as any device is conce...
