About j.spiess

j.spiess · 10-14-2013

Hello!We have a brand new RV320 with the latest firmware in our network. Setup is with 2 WAN connection. Primary is a static IP connection. Secondary is a PPPoE conection. When ISP Service at WAN1 is OK, we have no problem, but now our primary ISP co...

j.spiess · 08-02-2014

Hello!I had a similar problem.I just would like to let everybody know that Cisco Support was able to help:A simple procedure helped removing the outgoing NAT: Change Routing Mode to NAT, save, then switch back to Routing. After that my problem was so...

j.spiess · 08-02-2014

Hello!I just would like to let everybody know that Cisco Support was able to help:A simple procedure help removing the outgoing NAT: Change Routing Mode to NAT, save, then switch back to Routing. After that my problem was solved!JP.

j.spiess · 07-21-2014

Hello! I have just got the RV180 with newest firmware, an ran into a similar problem:We have public IPs assigned by our provider. The RV180 should route them through to further Servers/Firewalls. Even though NAT is DISABLED, somehow in a strange way,...

j.spiess · 12-21-2013

Hello!I just want everybody know, that the problem was finaly solved after a remote session with cisco support.It turned out to be a rather simple issue, that could have been easily avoided by proper interface design:Although there are multiple Check...

j.spiess · 10-28-2013

Hello!We just another Failure on WAN1 ISP side. Again no automatic switching - I unchecked NSD on WAN 2. See log below:2013-10-28, 14:18:54Network LogNSD FAIL WAN[1]2013-10-28, 14:18:59System LogWAN2=95.143.xx.xxx WAN2 MASK=255.255.255.255 WAN2_GATEW...

Member Since	‎10-14-2013 07:07 PM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	7
Total Helpful Votes Received	4

User Statistics

User Activity

WAN Failover with RV320 not working

Hello!I had a similar problem

Hello!I just would like to

Hello! I have just got the

WAN Failover with RV320 not working

Re: WAN Failover with RV320 not working