Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I just cannot get it to work. I need devices on siteA to connect to devices on siteB, both with overlapping IP's. Then if I am at siteA and want to ping siteB server at 10.10.10.100, what IP do I ping? I hope I make sense, because L2L vpn is kickin...
It should be simple, but I cannot get it. I want a device on 10.50.3.0 to access ASA management interface at 10.50.0.1.ASA Version 8.0(2) !hostname ciscoasadomain-name default.domain.invalidenable password ___ encryptednamesname 10.10.10.70 S2_serve...
Problem:A device connected to vlan 102 on Procurve 5406zl switch cannot communicate with Cisco ASA 5510; therefore, cannot get DHCP address.HELP! HP Procurve 5406zl:hostname "Admin"module 1 type j8705amodule 2 type j8702atime daylight-time-rule conti...
I cannot access the internet with my current configurations. Clients on vlan100/101 can obtain ip address but wired clients cannot access outside. What's weird is that I have mobiles devices ran off a Ruckus ZoneDirector and wireless APs in vlan101...
The above is a drawing of the network. I want a PC on 10.50.1.0 to access the webserver at 10.10.10.70. The PC and webserver are on default vlans of their switches.I believe I need a static NAT of some sort but all i've tried doesnt work.Here's con...
Most likely just the server on either end should suffice. siteA should be able to see siteB's internal 10.10.10.100siteB should see siteA internal 10.10.10.70 Do I change my static statement and access list configs then?
my config already has this, so it should work:http server enablehttp 10.50.3.0 255.255.255.0 WIRELESShttp 10.50.0.0 255.255.255.0 management telnet 0.0.0.0 0.0.0.0 managementtelnet 10.50.3.0 255.255.255.0 WIRELESS I tried adding a route but it alrea...
I can't believe that I cannot have a PC on the INSIDE interface access the MANAGEMENT interface through Asdm.I have the same interface command on for same security levels. I will try adding a route again.Sent from Cisco Technical Support iPad App
Okay, so what are my options in accessing the management interface without actually being plugged into it directly - as I do now and it's annoying.Thanks!
